TWGS/TW Gold Registration codes to enable 100 node TWGS,
standard TW2002 and Gold features. $80

This is what I ordered. When I installed it, I had a 4 node TWGS. Is there something I am missing or do I have a wrong reg code.

It usually takes a week or two to get your codes from JP via Email, have you done this yet? The unlock codes are not included in the download or order placement (note sure you might be trying to enter your order numbers or something), otherwise. If you have entered the correct codes they will change from red to green, it is best to copy and paste each one from your email into the field in your TWGS console. Otherwise, type each one in one at time and double check you have entered is correct as you go. Also, make you have entered the correct code in the correct prompt, I think two of them are a little confusing and the third is your server name, the SysOp name can be changed to whatever you wish, the others always have to be exact, if I recall.

Actually Rexx, I think you can just copy the whole set of codes and paste 'em all at once. Really couldn't be easier.
Did we hit it Mav? Or are your codes in and you just haven't enabled the rest of your nodes?

Someone please correct me if I'm wrong...it's been several months since I installed mine.

I've had my twgs set up with the codes for a couple of months. I am using it to test my scripts, so I just started using it everyday and while I dont need a 100 nodes for that I realized I only had four.

I just wanted to know if it is just a configuration error on my part or do I have a code for 4 nodes instead of the 100 nodes I paid for.

Mav

Yea that was is much easier Crosby, I am not sure if I have everything correct either, have not messed with that stuff in months...

Mav, also are you aware of the Gold Tools? if not you will want to install them after your codes are entered, they are at the very bottom of this long page, these allow you to use all the gold editor extentions, is a little tricky to get it working at first though, I had probs with installing it anyways:

http://eisonline.com/download/default.htm

Crosby made a good point about having your 100 nodes enabled that is also done in the config menu area, if your codes are all green in color, then that might be your issue. Also, make sure you are not having a Listener/Binding issue by insuring your IP or Port selection is not causing any conflicts, that may cause the 4 node default to occur.

Yep it was a config issue on my part. Thanks everyone for your help.

Mav

also if you want to use port 23 on your machine you have to make sure the telnet service on it is stopped or disabled cause it will cause a binding error if you use port 23 on the twgs.